What do you need to pay attention to when cutting security screen mesh?

securitymesh.com/uploadfile/2019/0110/20190110112813983.jpg" style="width: 200px; height: 170px; margin: 12px; float: left;" />It is common for security screen mesh to be used in industry. Cutting diamond mesh is also very common. But cutting the security screen mesh still needs to pay attention to some matters.

security screen mesh raw material is 304 stainless steel wire, surface protection adopts electrostatic spraying treatment, 304 stainless steel net has high anti-rust and anti-damage ability, after inspection, anti-invasive can reach 2.148 tons, anti-shear, anti-damage can be stronger, SS It is the abbreviation of "stainless steel", 316L is the trademark of stainless steel. There are three types of gauze of 304, 316 and 316L on the market. 304 contains 8 nickel (Ni) and contains less than 0.08 carbon. 316 contains nickel (Ni) 10 One, containing less than 0.08 carbon; 316L containing 12 nickel (Ni), containing less than 0.03 carbon; the lower the carbon content, the more anti-corrosion, the higher the nickel content, the more anti-corrosion.

The high-pressure water ejection should be used when cutting and welding the security screen mesh.

1. When manually transferring the cut material to the cutting work table or moving the parts after cutting, in order to prevent the high-pressure water from spewing out the injured workers, the residual pressure of the high-pressure water must be released beforehand.

2. In order to prevent the high pressure water recoil and the water jet from scattering when the cutting torch is set incorrectly or punched, the operator should be properly covered, so that the high pressure water jet is separated from the operator. .

3. For the water mist formed by the jet of water, if the plant does not have a total ventilation and exhaust equipment, at least the stomach ventilation and exhaust equipment should be equipped in the incision area.

4. In order to prevent backlash of high pressure water jet during the cutting process, the structure of the cutting workbench should be properly planned, and nozzle equipment can be installed at the head together.

5. After the end of one incision operation, and the high-pressure water ejection is turned off and on, the operator should check and acknowledge the following items so that the next incision operation can proceed smoothly.

After all, security screen mesh cutting is a bit more dangerous. I hope that everyone should be careful when operating. Avoid hurting yourself.