How to find the right one on the Security screen mesh market

Security screen mesh, anti-mosquito advantages. Accepted by many people. Therefore, there are more manufacturers in the market, and the quality of the produced Security screen meshs are also different. Sometimes the plastic powder on the surface of the Security screen meshs we buy will fall off, and we will briefly introduce the possible problems.

1. The quality of the powder is too poor. Use low-quality and low-quality recycled powder, or use powder that cannot withstand ultraviolet radiation in the room.

2. The quality of the mesh is too poor. The surface of the original mesh has impurities, dust, oil stains, or rust. The surface is not clean, which affects the electrostatic adhesion of the powder (generally this is a frequent occurrence).

3. The temperature of the oven is too low. Before the Security screen mesh enters the oven, the temperature inside must reach 210 degrees Celsius. If the temperature does not reach the powder, the powder cannot be completely melted.

4, heating time, only a long enough pipeline to achieve the optimal heating time ratio, this is a very important link

MAISHI specializes in the production of Security screen mesh

anti-theft screens, which can coordinate with the overall interior decoration. Moreover, our Security screen mesh

anti-theft window screen can effectively block ultraviolet rays, but it will not affect the line of sight and protect privacy. It is welcomed by the new and old users, especially the villa users. Security screen mesh

anti-theft screens will inevitably get stuck during use. The solution is that the spring preload is insufficient. You can pull the window screen to the bottom and release it. This will cause the screen screen to rebound. The diameter of the spring wire in the rebound device is too small, and the rebound force is not enough. You can find a window screen installation company to change the spring device. The window screen is used for a long time, and there is dust in the slideway, which causes too much friction, so it cannot rebound. You can pull it repeatedly or wipe it with a rag or brush it with a cleaning brush.

More popular articles