Is the surface of the surface of the Security screen mesh a poor quality product?

Security screen mesh sometimes customers buy the surface is more digging. Moreover, the latitude and longitude lines of the surface are not very straight. More distressed that I bought a counterfeit product. So is it really a bad product?

Maishi, the top manufacturer of Security screen mesh.com, explained the problematic introduction of the following Security screen mesh.

1. It may be that the weaving is not good.

If the manufacturer does not guarantee that the machine of the product is completely free of problems at the time of production, only one of them will show the problem of wire mesh weaving.

2, pull the net or the problem of the network.

In the process of pulling or smashing the net, the Security screen mesh splicing machine uses a roll of Security screen mesh to unfold and fix the two ends through the hydraulic top, and stretches the net with a certain pulling force. When we stretch, we loosen one corner. Stretching, there is a situation where the angle is short and the angle is short. It is commonly known as the "tuning angle". There is no problem in the general drawing process unless there are some difficult problems (for example, the quality of the net itself). And pull net master technology is not professional enough.

3. The problem of technical spray

Security screen mesh product pull net or Guoheng of the net, Security screen mesh is to spray the special powder for outdoor spray on the electrostatically charged mesh surface, then enter the oven to heat the surface of the plastic powder through high temperature, the temperature reaches 200 degrees Celsius . Our professional staff has consulted a lot of relevant information. In the process of pulling the net, the strength of pulling the net should not be too large, otherwise the mesh surface may be broken, and it should not be too small. Otherwise, the mesh surface is not flat, and it is said to be applied to it. The pulling force is greater than the metal yielding point, so that the mesh surface is deformed and there is no rebound phenomenon. At this time, if the placement time of the net is not correct, the surface of the Security screen mesh will be uneven.

More popular articles