How to install security screen mesh

Many people do not understand the specific method of assembling the security screen of security screen mesh Below, we will understand specifically.

1. Positioning the pay-off line: At the beginning, the middle line of the hole should be ejected, and the width of the hole should be determined from the middle line. The middle line of the middle window should be perpendicular to each layer. Then, the horizontal line of the same elevation is set on both sides of the hole, and the elevation of the horizontal line on the same floor should be the same. Be careful, the screen frame should fit in the center of the wall and be the same size as the corner of the wall.

2. Screen frame assembly flow: The position and opening bias of the screen window assembly must meet the planning requirements. We can use the level ruler to repeatedly correct the vertical warfare level of the door and window frame and mediate the vertical level of the wooden door and window frame. The rest, the number, position and connection method of the screen frame and the wall should be concealed.

The window frame of security screen mesh shall be inspected after assembly, and the deviation value shall be within the permitted range specified in the example.

After the security screen mesh is being applied for a period of time, the gauze will become clean, and the user will assemble the screen to hold the wash, but after the washing, many people do not assemble. Below, let's take a look at the specific response.

1. The position of the assembly is changed. Since the flowing plastic steel frames are not necessarily equidistant, the high and low frames are probably not parallel to each other, so it is necessary to find the space at the beginning of the space.

2. It is possible to insert the upper head first, use one foot to smash the center of the screen window, and gently push it inward, and the other foot pushes the screen window into the window frame, so that the screen window is slightly hidden. Be careful, you can't use too much force to prevent deformation of the screen window.

3. If the above two methods are not possible, the beam of the screen window assembly can be set down with a pair of tweezers. But be careful, don't be too much, let the screens fit out.